Can DataXchange support multiple buildings in different time zones?

Yes – this is fully supported with your account.

,

Does DataXchange support FANUC FOCAS?

Yes! Common data that is available through the FOCAS are CNC state (running, idle, alarm), part count information, program name, number, size, and date modified, tool and work offsets, alarm number and text, feed overrides, parameters, positional data, spindle speed, and Modal data.

In order to see if you have FANUC FOCAS available on your CNC, is to first check if you have Ethernet. To do that follow these steps:

  • Press the [SYSTEM] hard key
  • Press [>] approximately 5 times until you see *ETHEPRM*
  • Press [ETHRM] soft key, followed by [OPRT]
  • This will display the ethernet connections available
  • Select a connection (normally EMBEDD or BOARD)
  • Press the [DOWN] hard key. (page 2)
  • This should display FOCAS / ETHERNET

If those steps took you to the Ethernet page and/or the FOCAS page, then you’re good to go! Contact us for more information.

,

Does DataXchange support MTConnect?

Yes. MTConnect is a set of open, royalty-free standards intended to generate greater communication between CNC controls, device and software applications by publishing data over networks using the Internet Protocol.

Scytec DataXchange is the software application used to collect, report and chart the results of the data collection via a cloud-based solution.

Can I mix and match DataXchange versions?

Yes, you can mix and match versions under one account.

, , , ,

Can I monitor machine overrides?

Yes, you can monitor machine overrides with most FANUC FOCAS based controls or MTConnect enabled controls, you can easily monitor when your operators are turning the feed rates down.

What is a Status Relay Control (SRC)?

Via our DataXchange product page, the Status Relay Control (SRC) helps simplify ease of collection from equipment via a signal/combo of signals.

Connect to outputs from another system (EXAMPLE: a CNC, a PLC, or devices like a proximity sensor). Scytec DataXchange reads all inputs of status to help users create a better understanding of their machines.

More information about it:

  • for machines not MTConnect of FANUC FOCAS based
  • no programming required & has a low price
  • can be wired or wireless
  • has 8 data collecting inputs
  • 6 outputs for triggering
  • has an RS232 serial interface
  • is powered off 24 volts
  • typically used with Serial to Ethernet converter

For more information, contact the SFA Sales Department for an in-depth brochure on the SRC.